Banner
Introduction and characteristics of sand stone separator equipment
- 2018-11-12 -

The common sand and stone separator equipment on the market is also called concrete sand stone separator or concrete sand stone separation slurry water recovery equipment. It is an important equipment for concrete recovery system. The sand stone separator produced by Qingzhou Aiping Machinery Parts Factory is mainly used for Wash and separate the sewage from the tank car and the sand in the residual concrete. Qingzhou Aiping Machinery Parts Factory designs sand stone separator equipment using foreign mature concrete recycling method, combined with the characteristics of drum separation and spiral screening separation, saving you a lot of manpower, material resources and financial resources.

The sand stone separator equipment is relatively simple, and it can also produce the benefits of environmental protection: the surface of the sandstone is separated and clean, the sand contains ash1% , the water content is ≤ 3-5% ; the car wash water is used repeatedly, and the sewage reaches 0 . Emissions; equipment is not easy to wear, easy to operate, easy to clean and repair. The sand stone separator equipment system mainly consists of three parts, a car wash station, a separator yard and a pool.

The sand stone separator equipment is complete, easy to operate, energy-saving, pollution-free, and cost-effective. It mainly has the following characteristics:

1. PLC electric control box, using automatic programming control.

2. Simple operation (also manual).

3. The separation of sand and stone is relatively clean.

4. The control system adopts the original electrical appliances of well-known domestic manufacturers, with low failure rate and reduced maintenance.

5. The car wash water is used repeatedly and there is no sewage discharge.

6. Car wash cycle, the output is 1-50m3 / hour, the speed is 20 rev / min .

7. The wearable parts are reinforced and the service life is extended.

8. It can be designed according to the terrain of the site and the number of mixer trucks.

9. The outer shell steel is thick, reaching 8-10 mm , and it is placed in the open air for a long time, which is not easy to rust and corrode.

10. The screen mesh adopts the dry mesh type, which is convenient to disassemble and assemble, and is not easy to corrode and block. For example, the long-fiber concrete industry can still use it.

11. The main mixing system has a large volume and is easy to change.