Banner
Reasons for low sand quality of sand and stone separator equipment
- 2018-11-12 -

In actual production, the output of sand and gravel separator equipment is related to many factors.

First, the broken materials are different

Different materials, their hardness, viscosity, humidity, etc. will be different, sand and sediment machine equipment will have different sand discharge when broken. details as follows:

1 , the viscosity of the material

The greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the sand making chamber in the sand separator equipment. If it cannot be cleaned in time, it will seriously affect the working efficiency of the sand separator equipment. Therefore, when selecting materials, it should be noted that the viscosity of the materials should not be too large.

2 , the composition of the material

The more fine powder contained in the material before sand making, the more it affects the sand making, because these fine powders tend to adhere and affect the transport. Therefore, materials with a high content of fine powder should be sieved in advance, and the fine powder should be screened out from the materials as much as possible to avoid affecting the normal operation of the sand making machine.

3 , the humidity of the material

When the material with high water content is broken, it is easy to be clogged, resulting in a decrease in sand making capacity.

To solve this problem, it is necessary to strictly control the humidity of the material, and the percentage of moisture in the material can be reduced by using sunshine or air drying.

4 , the hardness of the material

The hard material wears the equipment more seriously, the sand making speed is slow, and the ability is small, which requires us to be moderate in the selection of materials.

 

 

Second, the fineness of the finished sand is different

The higher the fineness requirement, that is, the finer the material required to make sand, the smaller the sand making ability. In this respect, depending on the specific requirements of the concentrator, if there is no requirement, the fineness of the material is generally set to medium and fine.

Third, the sand machine model difference

Users should have an understanding of their own production when purchasing equipment, and purchase a sand-making machine that suits them. Otherwise, users may cost more.

Fourth, whether to standardize operations, regular maintenance

Standard operation of sand separator equipment. If a sand making machine is not standardized during operation and does not perform regular maintenance, it will cause the wearing parts of the equipment to wear faster, the life of the equipment will be greatly reduced, and the production volume per unit time will be small.

 

5. The quality of the sand making machine itself is different.

A high-quality sand-making machine not only saves energy, but also can achieve the expected output of the equipment. Not only that, high-quality equipment manufacturers use new materials in production, adopt higher production methods, and produce equipment that can complete users' Production demand provides a relatively guarantee for continuous production.

6. Is the design of the sand production line appropriate?

The output is related to all the equipment in the whole production line. For example, if your production requirement is 500t/h , then you can't just ask the sand production machine to reach 500t , the front smashing, cone breaking, belt conveyor, etc. To match it, otherwise the output will not be reached.