In the market for sand washing production, the use of crushing and sand washing equipment is relatively large, but due to the improper operation of many operators of crushing and sand washing equipment, or the operation according to the instructions, and the use environment of some crushing and sand washing equipment. Different, so there will often be a series of problems. For the four major problems common in broken sand washing equipment , Qingzhou Aiping Machinery Parts Factory will teach you how to solve these problems.
1 , bearing problems
Possible failure: The bearing is excessively worn and the assembly does not match.
Solution: The operator should be able to check the bearing of the crushing and sand washing equipment in time, and find that the bearing should be replaced in time to avoid the occurrence of other problems caused by excessive heating of the motor.
2 , the core problem of broken sand washing equipment
Possible failure: If the core of the broken sand washing equipment is rusted, the reason may be that the parts are damp.
Solution: sand the iron core of the broken sand washing equipment with sandpaper, and then apply a layer of insulating paint on the surface to prevent the next corrosion.
3. The problem of combining the iron core of the crushing and washing equipment with the machine base
Possible failure: loosening of the joint between the core and the base.
Solution: Tighten the original set screw. If it is not good, re-punch the hole on the base.
4 , the shaft problem
The shaft of the crushing and sand washing equipment is a relatively important component. If the shaft fails, the efficiency of the screw washing machine will be seriously affected.
Possible failure: journal wear on the shaft
Solution: Look at the degree of wear of the journal. If the wear is not very serious, you can directly apply a layer of chromium to the journal. If the wear is serious, cut a layer of chrome and then put the sleeve up.
- Classification and characteristics of spiral sand washing machine in Qingping Aiping Machinery Parts Factory
- How to deal with the rust of broken sand washing equipment
- How to operate after using second-hand sand making machinery to achieve good results
- Five common faults and solutions for crushing sand making equipment
- Causes and solutions for blocking sanding equipment
- What is the difference between the spiral sand washing machine and the wheel washing machine?
- Daily maintenance of sand and stone separator equipment
- What are the daily maintenance work of broken sand making equipment?
- Sand washing machine manufacturers explain the performance and structural characteristics of the sand washing machine